[Users] Re: How to assign a public IP to a VE ?

[U.Mutlu]

Gary Wallis wrote, On 2011-10-29 04:29:
> Sounds like a general networking vlan and/or bonding issue. But make sure that these /etc/vz/vz.conf parameters are set correctly:
>
> # The name of the device whose IP address will be used as source IP for CT.
> # By default automatically assigned.
> #VE_ROUTE_SRC_DEV="eth0"
>
> # Controls which interfaces to send ARP requests and modify APR tables on.
> #NEIGHBOUR_DEVS=detect

tried also with "all"

> ## Fail if there is another machine in the network with the same IP
> ERROR_ON_ARPFAIL="no"

Have it already so

> Also check the output of
>
> # route -n
>
> Make sure default gw (0.0.0.0) is on the correct device and that this device is plugged into the correct switch port.

The main IP is XXX.XXX.132.147/24, and the GW is XXX.XXX.132.1 .
The 2nd IP is XXX.XXX.131.15 .

The goal is to assign the 2nd IP to the VE.
Let's start on the HN. Is the following setup on the HN correct?

# ip a l
root at s7:/tmp# ip a l
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 16436 qdisc noqueue state UNKNOWN
     link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
     inet 127.0.0.1/8 scope host lo
2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast state UP qlen 1000
     link/ether 00:1b:21:ad:7b:d3 brd ff:ff:ff:ff:ff:ff
     inet XXX.XXX.132.147/24 brd XXX.XXX.132.255 scope global eth0
     inet XXX.XXX.131.15/24 brd XXX.XXX.131.255 scope global eth0:0
3: venet0: <BROADCAST,POINTOPOINT,NOARP,UP,LOWER_UP> mtu 1500 qdisc noqueue state UNKNOWN
     link/void

# ip r l
XXX.XXX.132.0/24 dev eth0  proto kernel  scope link  src XXX.XXX.132.147
XXX.XXX.131.0/24 dev eth0  proto kernel  scope link  src XXX.XXX.131.15
default via XXX.XXX.132.1 dev eth0

# route -n
Kernel IP routing table
Destination     Gateway         Genmask         Flags Metric Ref    Use Iface
XXX.XXX.132.0    0.0.0.0         255.255.255.0   U     0      0        0 eth0
XXX.XXX.131.0    0.0.0.0         255.255.255.0   U     0      0        0 eth0
0.0.0.0         XXX.XXX.132.1    0.0.0.0         UG    0      0        0 eth0

Both IPs can be pinged from outside.
If that's correct on the HN, then how should the /etc/network/interfaces on the VE look like?