[Users] IPv6 support in VE

[Thorsten Schifferdecker]

Hi,

adding is ok, but when i want delete a IPv6 with --ipdel, it shows:

# vzctl set <VEID> --ipdel fc00::1 [--save]
Warning: ipv6 support disabled <---*
Deleting IP address(es):
Configure meminfo: 49152
Saved parameters for VE <VEID>

Regards,
Thorsten

> Jan,
> 
> With venet, you use the same ipadd command, for example:
> 
> vzctl set VEID --ipadd fc00::01 --save
> 
> Before that, make sure that
> * your kernel is compiled with IPv6
> * ipv6 module is loaded (if IPv6 is compiled as a module)
> * IPV6 set to yes in /etc/vz/vz.conf
> 
> Kirill Korotaev wrote:
>> Jan,
>>
>> venet supports IPv6 addresses as well.
>> it's just an article concerning veth only :)
>>
>> Thanks,
>> Kirill
>>
>> Jan Tomasek wrote:
>>  
>>> Hello,
>>>
>>> what is state of IPv6 support inside VE? I found:
>>>
>>> http://wiki.openvz.org/Virtual_Ethernet_device#Virtual_ethernet_device_with_IPv6 
>>>
>>>
>>> but that looks quite complicated comparing to IPv4 where I just need to
>>> use `vzctl --ipadd 1.2.3.4` and that is all.
>>>
>>> Do I have to go with veth or is there chance how to configure IPv6 on 
>>> venet?
>>>
>>> Thanks for sugestions
>>>
>>>
>>> ------------------------------------------------------------------------
>>>
>>> _______________________________________________
>>> Users mailing list
>>> Users at openvz.org
>>> https://openvz.org/mailman/listinfo/users
>>>     
>>
>> _______________________________________________
>> Users mailing list
>> Users at openvz.org
>> https://openvz.org/mailman/listinfo/users
>>   
> 
> _______________________________________________
> Users mailing list
> Users at openvz.org
> https://openvz.org/mailman/listinfo/users