<div>Hi,</div>
<div>I have PC with centos 2.6.9-42.0.2.EL.</div>
<div> till yesterday it was working fine. yesterday I had to load Nistnet and it requires a RTC module. So I had to load this REal time Clock module from make menuconfig under device drivers, character devices, RTC. After this I did make modules_install and rebooted the PC . Now, when I start the PC, it shows
<br><br>Applying Intel Microcode update: FATAL: Module microcode not found<br>Error: module microcode does not exist in /proc/modules</div>
<div>the other error is dev eth0 has different MAC address than expected, so ignoring.</div>
<div> </div>
<div>At times it shows : device eth0 does not seem to be present, delaying initialization.<br><br><br>i did /sbin/ifconfig and saw that there is no eth0 related info. only loop back interface is present.<br>I also tried to do /sbin/ifup eth0 but it is not found. in the lspci, the driver for ethernet is REaltek 8139 and
<br>these modules are present in /lib/modules. however, if i try to do depmod and then modprobe 8139too.ko, the message is <br>FATAL: Module 8139too not found. if i do lsmod or /proc/modules.conf, i dont see the eth0 related modules there. Please
<br>tell me what I should do? There is some sunrpc for which also the module is missing. At present I am unable to connect this <br>pc to the rest of the network. The dmesg command gives a lot of output but there is no way I can send that to u as it is out
<br>of network now. Waiting for your reply</div>
<div><br>Thanks in advance,<br>Padmaja</div>