[Devel] Re: IO controller discussion (Was: Re: [PATCH 01/10] Documentation)

[Vivek Goyal]

On Sat, Apr 18, 2009 at 06:49:33PM +0530, Balbir Singh wrote:
> On Fri, Apr 17, 2009 at 7:43 PM, Vivek Goyal <vgoyal at redhat.com> wrote:
> > On Fri, Apr 17, 2009 at 11:37:28AM +0200, Andrea Righi wrote:
> >> On Thu, Apr 16, 2009 at 02:37:53PM -0400, Vivek Goyal wrote:
> >> > > I think it would be possible to implement both proportional and limiting
> >> > > rules at the same level (e.g., the IO scheduler), but we need also to
> >> > > address the memory consumption problem (I still need to review your
> >> > > patchset in details and I'm going to test it soon :), so I don't know if
> >> > > you already addressed this issue).
> >> > >
> >> >
> >> > Can you please elaborate a bit on this? Are you concerned about that data
> >> > structures created to solve the problem consume a lot of memory?
> >>
> >> Sorry I was not very clear here. With memory consumption I mean wasting
> >> the memory with hard/slow reclaimable dirty pages or pending IO
> >> requests.
> >>
> >> If there's only a global limit on dirty pages, any cgroup can exhaust
> >> that limit and cause other cgroups/processes to block when they try to
> >> write to disk.
> >>
> >> But, ok, the IO controller is not probably the best place to implement
> >> such functionality. I should rework on the per cgroup dirty_ratio:
> >>
> >> https://lists.linux-foundation.org/pipermail/containers/2008-September/013140.html
> >>
> >> Last time we focused too much on the best interfaces to define dirty
> >> pages limit, and I never re-posted an updated version of this patchset.
> >> Now I think we can simply provide the same dirty_ratio/dirty_bytes
> >> interface that we provide globally, but per cgroup.
> >>
> >> >
> >> > > IOW if we simply don't dispatch requests and we don't throttle the tasks
> >> > > in the cgroup that exceeds its limit, how do we avoid the waste of
> >> > > memory due to the succeeding IO requests and the increasingly dirty
> >> > > pages in the page cache (that are also hard to reclaim)? I may be wrong,
> >> > > but I think we talked about this problem in a previous email... sorry I
> >> > > don't find the discussion in my mail archives.
> >> > >
> >> > > IMHO a nice approach would be to measure IO consumption at the IO
> >> > > scheduler level, and control IO applying proportional weights / absolute
> >> > > limits _both_ at the IO scheduler / elevator level _and_ at the same
> >> > > time block the tasks from dirtying memory that will generate additional
> >> > > IO requests.
> >> > >
> >> > > Anyway, there's no need to provide this with a single IO controller, we
> >> > > could split the problem in two parts: 1) provide a proportional /
> >> > > absolute IO controller in the IO schedulers and 2) allow to set, for
> >> > > example, a maximum limit of dirty pages for each cgroup.
> >> > >
> >> >
> >> > I think setting a maximum limit on dirty pages is an interesting thought.
> >> > It sounds like as if memory controller can handle it?
> >>
> >> Exactly, the same above.
> >
> > Thinking more about it. Memory controller can probably enforce the higher
> > limit but it would not easily translate into a fixed upper async write
> > rate. Till the process hits the page cache limit or is slowed down by
> > dirty page writeout, it can get a very high async write BW.
> >
> > So memory controller page cache limit will help but it would not direclty
> > translate into what max bw limit patches are doing.
> >
> > Even if we do max bw control at IO scheduler level, async writes are
> > problematic again. IO controller will not be able to throttle the process
> > until it sees actuall write request. In big memory systems, writeout might
> > not happen for some time and till then it will see a high throughput.
> >
> > So doing async write throttling at higher layer and not at IO scheduler
> > layer gives us the opprotunity to produce more accurate results.
> >
> > For sync requests, I think IO scheduler max bw control should work fine.
> >
> > BTW, andrea, what is the use case of your patches? Andrew had mentioned
> > that some people are already using it. I am curious to know will a
> > proportional BW controller will solve the issues/requirements of these
> > people or they have specific requirement of traffic shaping and max bw
> > controller only.
> >
> > [..]
> >> > > > Can you please give little more details here regarding how QoS requirements
> >> > > > are not met with proportional weight?
> >> > >
> >> > > With proportional weights the whole bandwidth is allocated if no one
> >> > > else is using it. When IO is submitted other tasks with a higher weight
> >> > > can be forced to sleep until the IO generated by the low weight tasks is
> >> > > not completely dispatched. Or any extent of the priority inversion
> >> > > problems.
> >> >
> >> > Hmm..., I am not very sure here. When admin is allocating the weights, he
> >> > has the whole picture. He knows how many groups are conteding for the disk
> >> > and what could be the worst case scenario. So if I have got two groups
> >> > with A and B with weight 1 and 2 and both are contending, then as an
> >> > admin one would expect to get 33% of BW for group A in worst case (if
> >> > group B is continuously backlogged). If B is not contending than A can get
> >> > 100% of BW. So while configuring the system, will one not plan for worst
> >> > case (33% for A, and 66 % for B)?
> >>
> >> OK, I'm quite convinced.. :)
> >>
> >> To a large degree, if we want to provide a BW reservation strategy we
> >> must provide an interface that allows cgroups to ask for time slices
> >> such as max/min 5 IO requests every 50ms or something like that.
> >> Probably the same functionality can be achieved translating time slices
> >> from weights, percentages or absolute BW limits.
> >
> > Ok, I would like to split it in two parts.
> >
> > I think providng minimum gurantee in absolute terms like 5 IO request
> > every 50ms will be very hard because IO scheduler has no control over
> > how many competitors are there. An easier thing will be to have minimum
> > gurantees on share basis. For minimum BW (disk time slice) gurantee, admin
> > shall have to create right cgroup hierarchy and assign weights properly and
> > then admin can calculate what % of disk slice a particular group will get
> > as minimum gurantee. (This is more complicated than this as there are
> > time slices which are not accounted to any groups. During queue switch
> > cfq starts the time slice counting only after first request has completed
> > to offset the impact of seeking and i guess also NCQ).
> >
> > I think it should be possible to give max bandwidth gurantees in absolute
> > terms, like io/s or sectors/sec or MB/sec etc, because only thing IO
> > scheduler has to do is to not allow dispatch from a particular queue if
> > it has crossed its limit and then either let the disk idle or move onto
> > next eligible queue.
> >
> > The only issue here will be async writes. max bw gurantee for async writes
> > at IO scheduler level might not mean much to application because of page
> > cache.
> 
> I see so much of the memory controller coming up. Since we've been
> discussing so many of these design points on mail, I wonder if it
> makes sense to summarize them somewhere (a wiki?). Would anyone like
> to take a shot at it?

Balbir, this is definitely a good idea. Just that once we have had some
more discussion and some sort of understanding of issues, it might make
more sense.

Got a question for you. Does memory controller already have the per cgroup
dirty pages limit? If no, has this been discussed in the past? if yes,
what was the conclsion?

Thanks
Vivek
_______________________________________________
Containers mailing list
Containers at lists.linux-foundation.org
https://lists.linux-foundation.org/mailman/listinfo/containers